Q&A

motor starts knocking as I race the motor

I swithced out the speed sensor and I check the connnector to verify wires are live. signal is g...

the scanner scans that all 1- 6 cylinders have a misfire and the p0300 -p0306 codes start to flas...

My daughters 2000 Jeep Grand Cherokee went through some major repairs this summer. The last thing...

Greese leaking from my left wheel do to a bad axle shaft bearing. Rear brakes also has grease fro...

I was driving on the freeway and my jeep stalled out. It started after trying a couple of time. I...

Auto makes a low chirping like sound whild driving. It gets louder when I hit the brakes. If it i...

constant velocity knuckle.....cvc joint

Have been fighting this issue since last Sept. Have had Cat converter heat test, exhaust system c...

My jeep will run for 2 seconds , then the security system cuts it off .

While starting, all power lost (had to reset clock) and then tach and speedometer inop. Runs gre...

also dtc,p0201.I JUST REPLACED THE HEAD GASKET.

I will try feeling the exhaust I don't know anything about this other than what I have read ...

Don't know hwere to write reply to answers but the jeep has been checked for misfires and ha...

Not sure if EGR is correct, I have spent 4 momths trying to diagnose my Jeep have been to dealer ...