1993 Jeep Grand Cherokee Problem Reports

RepairPal Verified 1993 Jeep Grand Cherokee Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

When normal alignment practices do not bring components into the alignment specifications, offset upper ball joints are available.

The ABS light can come on, indicating an ABS pump motor circuit fault. This is most likely to occur in warmer areas (above 90° F) and usually after a quick stop, like a refueling. If no faults can be found in the pump motor circuit after proper diagnostics, there is a revised ABS control module which should correct this concern.

Electrical contacts in the tail lamp housing tend to break or melt, which can cause the brake lights to fail or work intermittently. Complete inspection of the tail light housing and bulbs is recommended before replacing any parts.

The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops.  There is also a revised vacuum check valve available to address this concern.

A ticking type noise may be noted from the engine area due to an exhaust manifold that has cracked where the pipes are welded; cracked manifolds should be replaced.

On the 3.9L V6 and 5.9L V8 the engine oil leaks at the distributor can be misdiagnosed as leaks from the intake manifold seal, oil pan gasket, or rear crankshaft (rear main) seal. A revised distributor is available if oil is found inside the distributor.

If the oil filter casing shows signs of distortion from excessive oil pressure, the oil pump should be replaced.

Failure in the blower motor power module (automatic temperature controls) or resistor block (manual AC) may cause the heater blower motor to work only on the high setting. The connector to the power module/resistor block is known to overheat (and sometimes melt). The connector or terminals should be replaced; a replacement connector is available.

External oil leaks from the valve cover gaskets, intake manifold gaskets (front or rear), and the rear crankshaft seal area are common. The rear main seal is an unlikely source. Normally, leaks in this area are from the bearing cap mating surfaces as well as the sealing surface between the oil pan and bearing cap.

On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.

Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.

Loose or worn suspension and steering components can cause a wobble or shaking in the steering wheel. It may happen at a certain speed and subside as the vehicle accelerates through the range. Tire balance can contribute to this as well.

The power window motor commonly fails in the front and rear doors. This may require replacement of the complete window regulator assembly which will include the window motor.

The AC evaporator drain commonly clogs and causes water to leak onto the passenger side floor. A sloshing noise may also be heard from the water inside the heater housing. Decaying organic debris in the housing may cause an odor. A service bulletin (TSB 24-06-96) was released; it describes how to clean the drain tube without removing the heater AC housing.

Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).