An abnormal noise may be noted from the HVAC blower motor. This can be caused by debris from the glove box entering the blower motor via the recirculation door. A screen is now available which can be installed over the recirculation air inlet to keep debris out of the blower motor.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2007 Jeep Compass problems
A no crank or no start condition may develop due to electronic lockup of the wireless control module (WCM), also referred to as the Sentry Key Remote Entry Module (SKREEM). When this module fails the remote keyless entry system will also not operate. The WCM is commonly replaced to correct this concern.
On 4x4 vehicles, the Electronic Stability Program (ESP) may not turn off when the "ESP off" button is pressed. Our technicians tell us a software update for the anti-lock brake system (ABS) control module is available for this concern.
Water leaks may be noted from the front and/or rear roof area. Our technicians recommend to inspect the roof ditch and sunroof - Check all grommets and plugs, reseal roof seams, and replace the sunroof drain tubes if necessary.
Front wheel drive vehicles may develop a fuel gauge fluctuation issue. Our technicians tell us that replacing the fuel sending unit, clocking the fuel module, and installing a fuel jumper hose may be required to correct this concern.
A fluid leak may be noted from the front struts and/or the vehicle may handle "rough" Our technicians tell us that replacing the leaking struts and installing a revised jounce bumper and dust shield should correct these concerns.
A swish sound may be heard from the rear over bumps. The repair may involve installing a shock cap on both rear shocks.
A clicking or scraping sound may be noted from the clutch pedal area when turning the steering wheel in the full down tilt position. Our technicians tell us the clutch switch stop flag may require modification to correct this concern.
A squeak noise may be noted when applying or releasing the clutch pedal. Our technicians tell us that lubricating the clutch master cylinder push-rod ball socket should correct the concern.
Clutch pedal "push back" may be felt towards the end of the pedal travel. The repair may involve removing the pedal arm "over-center" spring.