2009 Jeep Commander Problems
RepairPal has identified the most common problems with the 2009 Jeep Commander as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
A water leak from the sunroof and/or headliner is often caused by clogged or misrouted sunroof drain tubes. Inspecting the sunroof drain tubes should be the first step in checking for the cause of these type of water leaks.
The service 4WD system light may illuminate with no fault codes stored in the final drive control module (FDCM). Our technicians tell us a software update for the FDCM is available to correct this concern.
Owners have reported several instances of the interior door handles coming loose or breaking. The factory door handles are part of the entire door panel, so an OEM or factory repair would require replacement of the door panel at considerable cost. There are multiple aftermarket solutions involving removing the door panel to repair the original assembly, or retrofitting an aftermarket interior handle to address the issue.
Vehicles with manual temperature control may develop a condition where warm air is coming from the instrument panel outlets when cold has been selected. Our technicians tell us a revised air distribution housing is available to correct this concern.
The hard drive for the MYGIG radio may become corrupt. Symptoms would include: The radio does not go past the "Navigation is being activated" screen, music on the hard drive cannot be accessed, capacity of the hard drive shows 0. If all three of these symptoms are present the MYGIG radio software will require updating.
The fuel tank may become hard to fill and/or the fuel fill nozzle may shut off repeatedly while fueling. Our technicians tell us that various items including the fuel tank, vapor recirculation tube, fuel fill tube, or EVAP system canister control valve may be at fault. Proper diagnoses will be required to determine the exact cause of this concern.
A popping or groan type noise may occur when opening or closing one or more of the vehicle doors. This may be caused bu insufficient lube on the lower hinge roller axle. Applying a small amount of grease between the roller pin and the inside surface should correct this concern. Our technicians tell us if the grease is not applied in the correct location, the noise will remain.