» » »

Problems for specific Jeep Commander years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Newest reported 2008 Jeep Commander problems

 

Verified for the Jeep Commander

An abnormal noise may develop from the HVAC blower motor as a result of debris ingestion. After any debris is removed, an air baffle screen can be installed on the inlet opening under the cowl grill to try and prevent a re-occurrence of the problem.

10 Reports
Me Too

Verified for the Jeep Commander

A water leak from the sunroof and/or headliner is often caused by clogged or misrouted sunroof drain tubes. Inspecting the sunroof drain tubes should be the first step in checking for the cause of these type of water leaks.

79 Reports
Me Too

Reported by RepairPal and 2 others for the Jeep Commander

The thermostat may fail causing illumination of the Check Engine Light. A failed thermostat will require replacement.

3 Reports
Me Too

Reported by RepairPal and 5 others for the Jeep Commander

The engine may be hard to start and/or illuminate the Check Engine Light with code P0340/P0344 stored. The common repair is to update the Powertrain Control Module (PCM) software. In some cases replacement of the camshaft position sensor may also be required.

6 Reports
Me Too

Verified for the Jeep Commander

The hard drive for the MYGIG radio may become corrupt. Symptoms would include: The radio does not go past the "Navigation is being activated" screen, music on the hard drive cannot be accessed, capacity of the hard drive shows 0. If all three of these symptoms are present the MYGIG radio software will require updating.

3 Reports
Me Too

Verified for the Jeep Commander

Vehicles equipped with a MYGIG radio may encounter a dead battery condition. This can be caused by the radio not powering down properly. Flickering of the radio backlighting when the radio should be powered down would indicate a fault requiring replacement of the radio.

1 Report
Me Too

Verified for the Jeep Commander

The oil change monitor may illuminate prematurely. A powertrain control module (PCM) software update is available which should correct this concern.

2 Reports
Me Too

Verified for the Jeep Commander

3.7 V6 and 4.7 V8 engines may develop exhaust leaks due to broken exhaust manifold bolts. Exhaust manifold gaskets and bolts should be replaced as necessary.

75 Reports
Me Too

Verified for the Jeep Commander

A significant vibration with moderate braking at highway speeds may develop on vehicles stored outdoors for 3 months or more. This condition may be due to corrosion on the brake rotors. Our technicians tell us that normal driving for about a week should eliminate this issue.

3 Reports
Me Too

Verified for the Jeep Commander

The service 4WD system light may illuminate with no fault codes stored in the final drive control module (FDCM). Our technicians tell us a software update for the FDCM is available to correct this concern.

68 Reports
Me Too

Verified for the Jeep Commander

On Vehicles with a 4.7L or 5.7L V8 engine, the Check Engine Light may illuminate with code P2181 for a cooling system performance fault. Or technicians tell us that updated software for the powertrain control module (PCM) is available to correct this concern.

2 Reports
Me Too

Verified for the Jeep Commander

On Vehicles with a 3.7L V6 or 4.7L V8 engine, the Check Engine Light may illuminate with code P013A and/or P013C. Or technicians tell us that updated software for the powertrain control module (PCM) is available to correct this concern.

4 Reports
Me Too

Verified for the Jeep Commander

The fuel tank may become hard to fill and/or the fuel fill nozzle may shut off repeatedly while fueling. Our technicians tell us that various items including the fuel tank, vapor recirculation tube, fuel fill tube, or EVAP system canister control valve may be at fault. Proper diagnoses will be required to determine the exact cause of this concern.

2 Reports
Me Too

Verified for the Jeep Commander

Delayed engagement of the automatic transmission may be due to a faulty internal cooler return filter. Our technicians tell us all cooler filters with the "AB" suffix on the part number are suspect and should be replaced.

44 Reports
Me Too

Verified for the Jeep Commander

A squeak noise may be noted from the rear suspension. Replacement of the upper spring isolators and reorientation or the rear springs may be required to correct this condition.

6 Reports
Me Too
Ask a Question