» » »

Problems for specific Jeep Commander years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Newest reported 2006 Jeep Commander problems

 

Reported by Jeepr and 1 other for the Jeep Commander

There is a heat shield above the muffler to dampen the amount of heat transferred into the passenger side area through the floorboards. This heat sheild is composed of aluminum sheet and heat dissipative material. It is adhered to the floorboard pan via inexpensive nuts that look like they were made from stamped sheet metal. I think there was also some kind of adhesive compund, but that had dried up and is not doing its job anymore. On my jeep...

2 Reports
Me Too

Reported by Commanded Man and 17 others for the Jeep Commander

Many reports say that the plastic is breaking and cracking at the door handles of the Jeep Commanders. I have had mine replaced at the cost of $1200 for two of the them. The cause is the spring that activates the door latch when you pull on the handle. If you pull the handle and let it slap back into position, there is a part of the actual handle that will hit the plastic. The spring attached to the handle has a lot of strength and it will ove...

18 Reports
Me Too

Verified for the Jeep Commander

An abnormal noise may develop from the HVAC blower motor as a result of debris ingestion. After any debris is removed, an air baffle screen can be installed on the inlet opening under the cowl grill to try and prevent a re-occurrence of the problem.

9 Reports
Me Too

Verified for the Jeep Commander

A ringing sound may be noted from the driveshaft when shifting from drive to reverse and reverse to drive. The repair may involve replacing the automatic transmission output flange and applying "Stud N Bearing Mount Adhesive" to the transmission output shaft flange splines.

3 Reports
Me Too

Verified for the Jeep Commander

A water leak from the sunroof and/or headliner is often caused by clogged or misrouted sunroof drain tubes. Inspecting the sunroof drain tubes should be the first step in checking for the cause of these type of water leaks.

59 Reports
Me Too

Reported by RepairPal and 2 others for the Jeep Commander

The thermostat may fail causing illumination of the Check Engine Light. A failed thermostat will require replacement.

3 Reports
Me Too

Verified for the Jeep Commander

Use of a cell phone with the vehicles radio on can cause a buzz or clicking sound from the radio speakers. It is recommend to move the cell phone away from any components of the radio system if this occurs. Replacement of radio system components will not correct this concern.

3 Reports
Me Too

Reported by RepairPal and 5 others for the Jeep Commander

The engine may be hard to start and/or illuminate the Check Engine Light with code P0340/P0344 stored. The common repair is to update the Powertrain Control Module (PCM) software. In some cases replacement of the camshaft position sensor may also be required.

6 Reports
Me Too

Verified for the Jeep Commander

3.7 V6 and 4.7 V8 engines may develop exhaust leaks due to broken exhaust manifold bolts. Exhaust manifold gaskets and bolts should be replaced as necessary.

73 Reports
Me Too

Verified for the Jeep Commander

A significant vibration with moderate braking at highway speeds may develop on vehicles stored outdoors for 3 months or more. This condition may be due to corrosion on the brake rotors. Our technicians tell us that normal driving for about a week should eliminate this issue.

3 Reports
Me Too

Verified for the Jeep Commander

Our technicians tell us that various driveability issues and/or illumination of the check engine or electronic stability program (ESP) warning lights may occur on vehicles with 3.7L V6 and 4.7L V8 engines. A powertrain control module (PCM) software upgrade is available which may correct these issues.

2 Reports
Me Too

Verified for the Jeep Commander

EGR valve position sensor fault code(s) may be stored in the powertrain control module (PCM) resulting in illumination of the Check Engine Light. A PCM software upgrade is available which may correct this issue.

5 Reports
Me Too

Verified for the Jeep Commander

The service 4WD system light may illuminate with no fault codes stored in the final drive control module (FDCM). Our technicians tell us a software update for the FDCM is available to correct this concern.

45 Reports
Me Too

Verified for the Jeep Commander

Spark knock, noise/vibration/harshness, and/or Check Engine Light issues may develop. Our technicians tell us powertrain control module (PCM) software upgrades may correct these concerns.

1 Report
Me Too

Verified for the Jeep Commander

Vehicles with manual temperature control may develop a condition where warm air is coming from the instrument panel outlets when cold has been selected. Our technicians tell us a revised air distribution housing is available to correct this concern.

4 Reports
Me Too
Ask a Question