Although the coil pack is new, it only fires #1. No current passes through the new wire at all for #4. I tested it using a timing light which lights up on all the other wires but will not light at all on the #4 wire. I've been advised that a bad crankshaft position sensor could cause it or, the igniter control module.
I've had misfire on #4 cylinder after eliminated plugs, wires and the coil pack on 1996 Toyota 4Runner
by Repairdad in Johnstown, PA on October 14, 2013
3 answers 1 comment
ANSWER by globalhelper , October 14, 2013
SEEK DIAG AS NOT TO WASTE MORE TIME AND MONEY
ANSWER by pushrod , October 14, 2013
The coil pack is defective, even if it is new!!! Or you have replaced the wrong one!