The fuel pump went out, replaced with a new one. Car was turning over and firing but it quit firing, no spark.I was told from a friend to check relays and fuses, all good. Put on new crank sensor, no spark.I dont want to keep sticking money in it but its a good old work car.It is getting gas now, pump works fine.I dont want to but Im about ready to haul it to junk yard. PLEASE HELP...
Its a Dynasty, anyway turns over but wont start? No spark... on 1990 Dodge Caravan
by spikenlucy in Sargeant, MN on September 04, 2010
ANSWER by Johnny Mopar , September 07, 2010
Cam Position sensor and or wiring from either sensor to PCM, ASD Relay (supplies voltage to ignition and injectors). Also, Both sensors must be properly gapped. There is a fiber spacer that should have been on the Crank Position Sensor when you installed it. Without the spacer...no start!