X

Isuzu Recalls

Models : Isuzu Hombre
Brakes, October 20, 1997
Summary:VEHICLE DESCRIPTION: LIGHT DUTY PASSENGER PICKUP TRUCKS EQUIPPED WITH 4.3L ENGINES. THE FRONT BRAKE LINE CAN CONTACT THE LEFT-HAND SIDE OF THE ENGINE OIL PAN CAUSING THE BRAKE LINE TO WEAR TO THE POINT OF BRAKE FLUID LOSS DURING BRAKE APPLICATION.
Models : Isuzu Hombre
Body, Interior & Misc., September 22, 1997
Summary:VEHICLE DESCRIPTION: EXTENDED CAB PICKUP TRUCKS EQUIPPED WITH 60/40 FRONT BENCH SEATS AND EXTENDED CAB PICKUP TRUCKS AND 2-DOOR UTILITY VEHICLES EQUIPPED WITH MANUAL LOCKING RECLINER BUCKET SEATS. THE OUTBOARD SAFETY BELT WEBBING ON THE DRIVER'S AND/OR PASSENGER'S SEAT CAN SEPARATE DURING A FRONTAL IMPACT.
Models : Isuzu Trooper
Brakes, June 29, 1997
Summary:THE LEFT FRONT BRAKE LINES WERE INSTALLED IMPROPERLY AT THE ASSEMBLY LINE RESULTING IN INSUFFICIENT CLEARANCE BETWEEN THE BRAKE LINE AND AN UPPER CONTROL ARM OF THE SUSPENSION.
Models : Isuzu Pickup, Isuzu Rodeo
Electrical & Lights, May 24, 1997
Summary:AN INTEGRATED CIRCUIT WITHIN THE VOLTAGE REGULATOR CAN CONTAIN MANUFACTURING ERRORS.
Models : Isuzu Trooper
Suspension & Steering, March 13, 1997
Summary:THESE VEHICLES WERE MANUFACTURED WITHOUT A LOCK WASHER AND/OR SCREWS IN THE FRONT HUB.
Models : Isuzu Hombre
Body, Interior & Misc., January 30, 1997
Summary:THE TOP COAT PAINT SEVERELY PEELS DUE TO OVERBAKING OF THE POWDER PRIMER PRIOR TO THE TOP COAT APPLICATION. SINCE THE WINDSHIELD PRIMER AND ADHESIVE ADHERE TO THE TOP COAT PAINT ONTHE WINDSHIELD OPENING FLANGE, THE WINDSHIELD DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, "WINDSHIELD MOUNTING."
Models : Isuzu Trooper
Body, Interior & Misc., January 24, 1997
Summary:CERTAIN VEHICLES WERE MANUFACTURED WITH AN INCORRECT REAR CENTER SEAT BELT ASSEMBLY BUCKLE. THE MISBUILD INVOLVED FITTING A BUCKLE FOR ANOTHER MARKET WITH THE CORRECT U.S. SPECIFICATION SEAT BELT.
Models : Isuzu Amigo, Isuzu Pickup, Isuzu Rodeo
Body, Interior & Misc., November 25, 1996
Summary:THE LATCH PLATE USED IN THE SEAT BELT BUCKLE WAS NOT MANUFACTURED ACCORDING TO DESIGN DIMENSIONS. IF THE SEAT BELT TONGUE IS INSERTED SLOWLY AT AN ANGLE INTO THE BUCKLE, THERE IS A POSSIBILITY OF PARTIAL ENGAGEMENT.
Models : Isuzu Hombre
Electrical & Lights, May 24, 1996
Summary:A BRAZILIAN DOMESTIC HEADLAMP WAS INADVERTENTLY INSTALLED ON THESE VEHICLES INSTEAD OF THE REQUIRED U.S. DOMESTIC ASSEMBLY. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
Models : Isuzu Pickup
Body, Interior & Misc., February 5, 1996
Summary:THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.