X

Isuzu Hombre Recalls

Models : Isuzu Hombre
Body, Interior & Misc., July 14, 2003
Summary:ON CERTAIN PICKUP TRUCKS WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.
Models : Isuzu Hombre
Body, Interior & Misc., October 20, 2000
Summary:VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES. SOME OF THESE VEHICLES WERE BUILT WITH INCORRECT PAYLOAD INFORMATION ON THE VEHICLE CERTIFICATION LABEL. THE PAYLOAD SHOWN ON THE LABEL IS GREATER THAN THE MAXIMUM VALIDATED PAYLOAD. IF THE VEHICLE WERE LOADED TO THE INCORRECTLY LABELED PAYLOAD, IT MAY NOT RIDE AND HANDLE IN THE MANNER THAT THE DRIVER EXPECTS.
Models : Isuzu Hombre
Body, Interior & Misc., December 15, 1998
Summary:VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES, 2 AND 4-WHEEL DRIVE. SOLDER JOINTS NEAR THE WIRING HARNESS CONNECTOR CAN CRACK CAUSING THE WINDSHIELD WIPERS TO WORK INTERMITTENTLY.
Models : Isuzu Hombre
Electrical & Lights, November 14, 1997
Summary:VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND MULTI-PURPOSE VEHICLES. AN ENGINE ELECTRICAL WIRING-HARNESS CLIP CAN MELT AND DRIP ONTO THE EXHAUST MANIFOLD.
Models : Isuzu Hombre
Brakes, October 20, 1997
Summary:VEHICLE DESCRIPTION: LIGHT DUTY PASSENGER PICKUP TRUCKS EQUIPPED WITH 4.3L ENGINES. THE FRONT BRAKE LINE CAN CONTACT THE LEFT-HAND SIDE OF THE ENGINE OIL PAN CAUSING THE BRAKE LINE TO WEAR TO THE POINT OF BRAKE FLUID LOSS DURING BRAKE APPLICATION.
Models : Isuzu Hombre
Body, Interior & Misc., September 22, 1997
Summary:VEHICLE DESCRIPTION: EXTENDED CAB PICKUP TRUCKS EQUIPPED WITH 60/40 FRONT BENCH SEATS AND EXTENDED CAB PICKUP TRUCKS AND 2-DOOR UTILITY VEHICLES EQUIPPED WITH MANUAL LOCKING RECLINER BUCKET SEATS. THE OUTBOARD SAFETY BELT WEBBING ON THE DRIVER'S AND/OR PASSENGER'S SEAT CAN SEPARATE DURING A FRONTAL IMPACT.
Models : Isuzu Hombre
Body, Interior & Misc., January 30, 1997
Summary:THE TOP COAT PAINT SEVERELY PEELS DUE TO OVERBAKING OF THE POWDER PRIMER PRIOR TO THE TOP COAT APPLICATION. SINCE THE WINDSHIELD PRIMER AND ADHESIVE ADHERE TO THE TOP COAT PAINT ONTHE WINDSHIELD OPENING FLANGE, THE WINDSHIELD DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, "WINDSHIELD MOUNTING."
Models : Isuzu Hombre
Electrical & Lights, May 24, 1996
Summary:A BRAZILIAN DOMESTIC HEADLAMP WAS INADVERTENTLY INSTALLED ON THESE VEHICLES INSTEAD OF THE REQUIRED U.S. DOMESTIC ASSEMBLY. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."