These vehicles are being recalled because the headlamp driver module (HDM) can overheat and fail. This will cause the headlights and daytime running lights to stop working. Loss of this lighting will affect the ability of the driver to see the road and reduce the vehicle's visibility to oncoming vehicles, both of which increase the risk of a vehicle crash. The remedy for this problem is still under development and not yet available.
Isuzu Ascender Recalls
Fluid may enter the driver's door module, causing corrosion that could result in a short circuit in the door module. A short circuit may cause the power door lock and power window switches to function intermittently or become inoperative. The short may also cause overheating, which could melt components of the door module, producing an odor, smoke, or a fire. Dealers will inspect the driver's door module, if it is functioning correctly, a protective coating will be applied. If the module is not functioning correctly, it will be replaced. The GM recall number is 12180.
Vehicles first sold, or currently registered, in certain states where salt is used to de-ice the roads are being recalled because fluid may enter the driver's door module, causing corrosion that could result in a short in the circuit board. A short may cause the power door lock and power window switches to function intermittently or become inoperative. The short may also cause overheating, which could melt components of the door module, producing an odor, smoke, or a fire. As of this time, the remedy plan is still being finalized and a notification schedule has not been determined. The GM recall number is 12180.
The tire and loading information label on the driver's side door frame may be inaccurate. A misprinted label could lead to overloading of the vehicle, which could possibly lead to tire failure and a crash. Owners will be provided with corrected labels and installation instructions. At customers' request, a dealer can install the label for them. The recall began March 31, 2006. The GM recall number is 05109.
Some vehicles have a power steering hose that was not made to specification and may rupture under extreme steering conditions. If this were to happen, power steering assist would be lost and steering effort would increase. On vehicles equipped with hydro-boost brakes, braking effort would also increase. If power steering fluid were to spray on hot engine parts, an engine compartment fire could also occur. Dealers will inspect the power steering hose(s) for the two suspect date codes and replace them if needed. The recall began October 14, 2005. The GM recall number is 05086.
The turn signals may operate like hazard flashers when intending to signal for a turn. The driver may not be able to clearly signal their intentions, increasing the risk of a crash. Dealers will replace the suspect flasher modules with a new flasher designed with sealed relays for better durability. The recall began August 4, 2005. The GM recall number is 05044.
The windshield may not be properly adhered to the body. If a crash occurs, the windshield could separate from the vehicle, increasing the risk of injury. Dealers will replace the windshield free of charge. This recall is expected to begin on March 10, 2005. The General Motors recall number is 05002.
The windshield wipers may not turn on, turn off while in operation, or may not turn off. The windshield washer pump may operate continuously as well. Water in the wiper modules can cause a short circuit or can corrode the components in the module. Depending on the condition, this could cause reduced visibility, which could result in a crash. Dealers will replace the windshield wiper system assembly. The recall began on July 15, 2004.
The owner's manual does not explain the location symbols for the lower child seat anchors. This does not comply with the Federal Safety Standard. Owners were sent a supplement to the owner's manual describing the location symbols for the child restraint anchors. Owner notification began on August 15, 2003.