1995 Ford Aerostar Q&A
1995 Ford Aerostar Question: Intake Manifolds
If you are going to tackle a job like this, make the small investment in a repair manual, either a book or an online subscription to alldatadiy or autozone. Read the instructions a few times, make sure you have all the tools and time to complete the job. This takes an experienced technician 3-5 hours, figure at least 6 for the first time! - Bret Bodas
where is the evap purge valve located?
I've run the devil out of my Aerostars over the years -- and I now still have my third one a 91 with a 3.0 which I have used as a commercial vehicle in the past with good success (including the cla...
i have a pin hole in my heater hose.The hose splits off three ways one go's to the intake manifold and one go's to the heatercore and one runs to a metal pipe that runs across the front of the moto...
Do you have a picture of the EGR valve location on this van
3.0L. I can't see the EGR Valve from of van, nor through dog house.Where the heck is it? Below?Local Auto Parts Stores tell me conflicting stories.Some tell me it's located off the intake manifold-(which I already knew)-others say it Don't have one?
Engine pulsates up & down, up, & down "at cold start only," then runs evenly, but lacks major power. Bad Gas Millage, but no emmisions smell really. It's a 3.0liter short-wheel base van w/ rebuild ...