Resources for the Repair and Maintenance of your Infiniti I35
Infiniti I35 Models:
Infiniti I35 Problems
Check Engine Light and Engine Stalling
The crankshaft angle sensor or the camshaft position sensor can fail and cause loss of engine power, an engine that cuts out, and other drivability problems. This will cause the Check Engine Light to illuminate. Certain models have been involved in a recall to replace the camshaft and crankshaft sensors. For more information on this recall, please click here»
Infiniti I35 Recalls (Recent)
Injury Due to Airbag Deployment
RepairPal Expert Overview:
Airbags use a chemical reaction contained in an inflator module to create the pressure necessary to inflate the bags when deployment is required. These vehicles are being recalled because the front passenger airbag inflator may produce excessive internal pressure when deployed. As a result, the inflator module could rupture, causing metal fragments to strike vehicle occupants. Dealers will inspect and replace any defective passenger front airbag inflator modules found.
Learn more »Infiniti I35 Recall 02V043000
Summary: ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH AN ELECTRONIC THROTTLE CONTROL SYSTEM, THE STOPPER FOR THE ACCELERATOR PEDAL WILL PREVENT EXCESSIVE MOVEMENT OF THE ACCELERATOR POSITION SENSOR. IF THE DRIVER APPLIES OVERLY EXCESSIVE FORCE TO THE ACCELERATOR PEDAL WHILE AT THE SAME TIME PUSHING IT TO THE RIGHT, THE PEDAL CAN "OVER TRAVEL" DUE TO THE DESIGN OF THE PEDAL STOPPER.
Learn more »Engine May Stop Running Without Warning
RepairPal Expert Overview:
The circuit board for the crank position sensor and cam position sensor may have improper solder joints. This could cause the Service Engine Soon lamp to come on, the engine may not start, you could experience reduced power, or the engine may stall without warning, which could result in a crash. Dealers will replace the the crank position sensor, cam position sensors, and in some cases, the variable timing control sensors. The recall began on December 22, 2003. The Nissan recall number is R2022 and the Infiniti recall number is R3021.
Learn more »Infiniti I35 Recall 02V146000
Summary: ON CERTAIN PASSENGER VEHICLES, THE PIN AT THE END OF THE FRONT SUSPENSION TRANSVERSE LINK (LOWER CONTROL ARM) COULD BREAK WHERE IT IS MOUNTED TO THE FRAME.
Learn more »Infiniti I35 Questions and Answers
Where should I go to have catalytic converter installed? dealer vs Independent? I have 169,500 miles. What happens if i don't get it repaired right away?
For several months I've noticed that the engine is more difficult to start when warm. Today it wouldn't start, I had to wait about ten minutes after my errand was over to drive away. From...
where is the camshaft position sensor located on i35 infiniti
just occurred first time. What caused this? How can it be fixed? Is there a manual override?
I took this car in for a tune up and have been told it will cost $800 for the tune up and $191 to replace a valve cover gasket. I know the intake manifold has to come off to do this but it seems h...
Infiniti I35 Reviews
This car is a gem.I only have two problem with it.I changed the struts 6 months ago and it feels like the front right is messed up.I had the car checked and everything is fine.The other is the pinging when I step on the gas.Is their anything I could do to fix this?Any additive that could fix this?
The service engine light come on after the vehicle reached 70,000 miles as the same time begin losing power
I have several problems:
1. I hardly ever open the sun roof. Now if I want to open it, it won't open. I don't know the cause.
2. I recently had to replace the struts. I never had this problem with any car.
3. When I click to open the doors, only the driver's door opens right away. I have to click 3 more times to get the other doors to open.
4. I recently had to replace a leaking radiator. Another first for me with ANY car.