2003 Infiniti G35 Problems

RepairPal has identified the most common problems with the 2003 Infiniti G35 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
7
Known Problems

Rattling and tapping in the front of the engine on the 2003-2007 G35 is very evident, especially on cold starts. This rattling noise should not be taken lightly as it warns of upcoming timing chain failure. 

The cause of the noise is faulty timing chain guide rails and timing chain tensioners that wear out well ahead of schedule. These components are there to keep the timing chain tight and properly positioned. When these parts fail, the timing chain becomes loose, and pieces of the timing chain guides break off, falling into the oil pan. 

To remedy the situation, Nissan/Infiniti has made revised guides and tensioners, but replacement can be very costly. 

Proper oil change intervals and oil type may help slow or prevent the situation. 

The throttle body for the Infiniti G35 is known for carbon buildup, and requires regular, light cleaning to maintain peak performance. After cleaning the throttle body, many owners notice a very high idle, erratic (bouncing) idle, and unpredictable power surging. 

The cause is normal ECU adaptation: When the throttle body builds up carbon, the rate of airflow is slightly decreased. The vehicles computer reads this decrease in air volume, and adjusts the throttle body settings to maintain the proper engine idle speed. When the carbon is cleaned out, the ECU now registers too much air, and cannot adjust back to the original settings. While it is trying to change settings, the idle will bounce from low to high, and the car will surge forward at times. 

It has been recommended to simply wipe inside the throttle body every 12,000 miles, and never to touch the flap inside. Also, the cleaning procedure may be best left to a qualified technician.

The solution can be as simple as disconnecting the battery for at least an hour, having the dealer reset the computer, or, in extreme cases, replace the throttle bodies. 

The crankshaft angle sensor or the camshaft position sensor can fail and cause loss of engine power, an engine that cuts out, and other drivability problems. This will cause the Check Engine Light to illuminate. Certain models have been involved in a recall to replace the camshaft and crankshaft sensors. For more information on this recall, please click here»

The brake light switch may fail to operate the brake lights; a recall was issued.

Hard shifting or wrong gear selection may be corrected by reprogramming the automatic transmission ECU.

The fuel filler hose may crack and cause a leak when refueling, which could lead to fire. A recall was issued and the fuel hose will be replaced under warranty.