Ignition Lock Cylinder May Fail (Key Will Not Turn) on Isuzu Ascender

A no start condition may be caused by a failed ignition lock cylinder (the ignition key will not turn). If this occurs the ignition lock cylinder will require replacement.

RepairPal Verified
Average mileage: 83,666 (65,000–99,000)
2 model years affected: 2005, 2006
5 people reported this problem
2 people shared problem details
2005 Isuzu Ascender87,000
My key got stuck int he ignition after car started. Could not turn off car or pull out key. Had to remove fuse for ignition to turn off car so I can later tow it to mechanic to check out car and fix. Was not able to drive car since it would sometimes turn off when low idling at red light. Hope problem is just ignition lock that needs to be replaced.
Put key in ignition and it will not turn . Had to leave my car in Wendy's parking lot till tomorrow morning . This is the second time in six months that we have to put money into this car . The first time cost us around $ 1,200 . I'm sure this will cost around the same or more . I just can't win
Related Items:
Isuzu Ascender 2003 Ignition electrical ignition problem- Sometimes will not or can not turm to...
The ignition switch may fail resulting in a no start condition. Replacement of the failed switc...
The fuel level sensor may fail resulting in erratic reading of the fuel gauge. Sensor replaceme...
The engine cooling fan may fail resulting in illumination of the Check Engine Light and a possi...
The transmission may develop a harsh shift condition with the Check Engine Light on and fault c...

Related Content