Get the latest advice about your car

Get Started
Advice » Q&A » 2001 Honda Accord

Q&A

Ask Your Question

2001 Honda Accord

Question: I have a 2001 honda accord 3.0 V6 motor and i have replaced the injectors and

Question

ms Generator, 3.0L V6, Jackson, MS, September 27, 2011, 18:15
Profile_thumbnail
 Rookie

coil packs the wiring harnest on #2 coil has a good hot key ground but the positive coil pack wiring harnest is not pulsating and is overheating the coil pack and thats the only cylinder misfiring the check engine light is on .And also can you jump a wire from the #4 harnest connecter to the #2 to correct that

1 Answer
Answer It
Flag This

  • Answer #1

    patrick mannion from Greg Solow's Engine Room, September 27, 2011, 21:20
    Profile_thumbnail
     Master

    Check the integrity of the wiring from the injector to the ECU, if it is good the driver in the ECU may be bad. It's hard to say without verifying your test results myself. Honda ECUs are pretty good. A company called Fuel Injection Corporation in Livermore CA are best at testing the ECU for faults and repairing the ECU if it has failed. There is a company that independent auto repair shops get their information from, this same information is available inexpensively for people that work on their own cars.. The information is year make and model specific, covering repair procedures, torque specifications, fluid capacities and specifications, service bulletins, component locations, wiring diagrams ect.... Alldata is very easy to navigate http://bit.ly/AllData_Repair_Manuals_Online

    Reply
    Flag This
Answer Ranks

This week's top 10

1 globalhelper 6 Autohaus Lake Norman
2 milesauto 7 TimGoodreau
3 csubak30 8 raiderron
4 jose8889 9 Merrimack Auto
5 obdcar 10 2004toycam