i got a code p2614 i wanna know how the part look like & where in the motor it goes? on 2003 Ford F-250 Super Duty

i got a code p2614 i wanna know how the part look like & where in the motor it goes?

by in Pittsburg, CA on February 21, 2011
3 answers
ANSWER by on February 21, 2011
P2614 indicates you have a problem with the "Cam Position Output Circuit" or essentially a problem with the cam sensor signal. Before throwing a part on there, I would suggest a throough diagnostic test to determine the exact cause. What is the symptom? Does the engine run differently?
ANSWER by on February 21, 2011
I would suggest that the P2614 is merely an additional symptom of a problem unrelated to the cam signal that actually set when the vehicle would not start. Yes?
ANSWER by on July 06, 2011
Hello the service engine soon light comes on when there is a system fault the computer found during the self monitor drive cycle.There is always a cause and affect to each fault code.My question is does the vehicle start and if so how does the engine run?