The heated washer module under the hood could overheat due to excessive current draw. Under certain conditions, this could result in an under hood fire. This previous recall attempt in 2008 to repair this concern did not have the expected success. Dealers will now permanently disable and remove the heated washer module to correct this concern. This recall is expected to begin on June 20, 2010.
The retaining clips on the non-functional hood louver could brake. The louver could become loose and/or separate from the vehicle. If this were to happen while the vehicle is in motion, personal injury or property damage could result. Dealers will apply adhesive to the underside of the hood louver to secure it. The recall is scheduled to begin on April 12, 2010. The General Motors recall number is 10088.
The front fuel tank support strap may fracture. It it does, the fuel tank would only supported by the rear support strap and the stone shield. Continued driving would eventually fracture the rear support strap and shield fasteners. The fuel tank separating from the vehicle could increase the risk of a crash. Dealers will install an updated fuel tank support strap. The recall began April 10, 2009. The General Motors recall number is 09048.
Water may enter the windshield wiper motor module resulting in damage over time. The wipers may work intermittently or not at all. Visibility could be reduced, increasing the risk of a crash. Dealers will inspect the wiper module cover and replace it if necessary to correct this concern. The General Motors recall number is 08243.
The wiring to the washer system heater may overheat due to a failure in the heater module. This could cause other electrical features to malfunction, smoke to develop, and an electrical fire could result. Dealers will install a wire harness with an inline fuse to protect the washer heater module. This recall is expected to begin on September 12, 2008. The General Motors recall number is 08048.
On some trucks, wiring for the ABS wheel speed sensors may be reversed, which could cause increased stopping distance. This condition could increase the risk of a crash. Dealers will correct the ABS wheel speed sensor wiring and reprogram the brake control module if necessary.
The tire and loading information label on the driver's side door frame may be inaccurate. A misprinted label could lead to overloading of the vehicle, which could possibly lead to tire failure and a crash. Owners will be provided with corrected labels and installation instructions. At customers' request, a dealer can install the label for them. The recall began March 31, 2006. The GM recall number is 05109.
Some vehicles have a power steering hose that was not made to specification and may rupture under extreme steering conditions. If this were to happen, power steering assist would be lost and steering effort would increase. On vehicles equipped with hydro-boost brakes, braking effort would also increase. If power steering fluid were to spray on hot engine parts, an engine compartment fire could also occur. Dealers will inspect the power steering hose(s) for the two suspect date codes and replace them if needed. The recall began October 14, 2005. The GM recall number is 05086.
The second row center seat belt routing may make it difficult to position correctly on smaller passengers. If the seat belt rides up to fit around the abdomen, the risk of internal injury is increased in a crash. Dealers will cut the guide loop, remove a portion of the loop, and the remaining sides should be folded over and secured with a retainer. The recall began July 21, 2005. The GM recall number is 05037.