Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2006 Hummer H2 problems
One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.
A clicking noise may be noted from the turn signal flasher after the turn signals are switched off. This is commonly cause by a faulty turn signal switch which will require replacement.
Units with 4 wheel disk brakes may develop at situation where the park brake does not hold as it should. Our technicians tell us this can be caused by worn park brake shoes located inside the drum section of the rear brake disks. The worn shoes should be replaced and properly adjusted to correct this issue.
The fuel pump may fail causing the engine to stall and not restart.
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
After my H2 is parked awhile (mostly overnight), I will find the rear end has "dropped" approximately 6" as compared to the height of the front end. The rear end will regain its height once the engine is turned on. This happens intermittently.