2003 Hummer H2 Problem Reports

RepairPal Verified 2003 Hummer H2 Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.

A clicking noise may be noted from the turn signal flasher after the turn signals are switched off.  This is commonly cause by a faulty turn signal switch which will require replacement.

The battery may leak acid at the battery cable connections. As a result corrosion may form on the battery cable ends. Leaking batteries should be replaced and the cables need to be thoroughly cleaned or replaced if necessary.

The anti-lock brake system (ABS) pump may stay running after the ignition is turned off causing the battery to go dead. Our technicians tell us that the ABS control module should be replaced to correct this fault.

Units with 4 wheel disk brakes may develop at situation where the park brake does not hold as it should. Our technicians tell us this can be caused by worn park brake shoes located inside the drum section of the rear brake disks. The worn shoes should be replaced and properly adjusted to correct this issue.

The CD player may fail due to an internal fault with the radio. Our technicians tell us that in most cases, the radio unit will need to be sent to a specialty repair shop to correct this issue.

A dirty throttle body may cause a lower than normal idle and possible stalling condition. Performing a throttle body service will commonly correct this concern.

It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.

The steering wheel position sensor may fail, resulting in the service stability message being displayed.