how to replace clutch slave cylinder? on 2001 Mazda B2300

Do I have to drop the transmission to replace the clutch slave cylinder? Is this an expensive repair if done at service dept?

by in Dumas, AR on February 02, 2010
2 answers
ANSWER by on February 02, 2010
It is a 4 to 4.5 hour job to replace the slave cylinder on a 2 Wheel Drive.. The transmission must be removed to gain axcess to the slave cylinder.
ANSWER by on August 09, 2010
Yes you have to pull the tranie, the slave cyl is held in by 2 10 mm bolts behind the release bearing ,
Related Items:
How come I still don't have pressure after replacing master,slave cylinder? I have bled 2 quarts of brake fluid through the system and still don't have pressure. I do have suction at the master cyl...
replaceing the clutch assembly, parts indicate a bearing attached to the transmission useing a fluid to operate. how do I remove the bearing properly, it has two bolts and a fluid cable.
i have a manual transmission and i was wondering how i could fix first gear.? and why this could have worn out. it only has 127000 miles and we just replaced the master and slave cylinder. and the ...

Related Content