Honda Passport Recalls

Summary:
CERTAIN SPORT UTILITY VEHICLES THAT HAVE BEEN EXPOSED TO FUEL CONTAMINATED WITH SILICON MAY DEVELOP SMALL PIN HOLES IN THE FUEL PUMP FEED PORT. SILICON HAS BEEN IDENTIFIED IN THE FUEL SYSTEMS OF AFFECTED VEHICLES AND IN CERTAIN FUEL AVAILABLE IN THE REGION OF TYLER, TEXAS. THIS RECALL WILL BE LAUNCHED FOR VEHICLES REGISTERED IN TEXAS AND THE FOUR SURROUNDING STATES: OKLAHOMA, ARKANSAS, NEW MEXICO AND LOUISIANA.
Summary:
ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS, THE LATCH PLATE USED IN THE SEAT BELT BUCKLE WAS NOT MANUFACTURED ACCORDING TO DESIGN DIMENSIONS. IF THE SEAT BELT TONGUE IS INSERTED SLOWLY AT AN ANGLE INTO THE BUCKLE, THERE IS A POSSIBILITY OF PARTIAL ENGAGEMENT.
Summary:
ON CERTAIN SPORT UTILITY VEHICLES, THE PASSENGER-SIDE AIR BAG INFLATOR MODULES WERE MANUFACTURED AND SHIPPED WITHOUT A NECESSARY COMPONENT KNOWN AS A CHECK VALVE PIN.
Summary:
VEHICLE DESCRIPTION: CERTAIN SPORT UTILITY VEHICLES WERE BUILT WITH THE INFLATORS IN THE PASSENGER SIDE AIR BAG MODULES HAVING THE WRONG AMOUNT OF GENERANT.
Summary:
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. PAINT WAS APPLIED UNEVENLY ON THE REAR AXLES, RESULTING IN INSUFFICIENT PAINT HARDNESS. SHOULD THIS OCCUR ON THE SURFACE THAT CONTACTS THE REAR AXLE LOWER LINK BRACKET BOLT HEAD AND/OR NUT, THE NUT MAY LOOSEN.
Summary:
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. A GROUND CONNECTION TERMINAL WAS NOT PROPERLY CRIMPED IN THE SUPPLIER'S ENGINE WIRING HARNESS MANUFACTURING LINE. THIS IMPROPER CRIMPING PROCESS CAN LEAVE AN IMPRESSION ON THE TERMINAL THAT WILL EVENTUALLY CAUSE A STRESS FRACTURE. S
Summary:
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. A GROUND CONNECTION TERMINAL WAS NOT PROPERLY CRIMPED IN THE SUPPLIER'S ENGINE WIRING HARNESS MANUFACTURING LINE. THIS IMPROPER CRIMPING PROCESS CAN LEAVE AN IMPRESSION ON THE TERMINAL THAT WILL EVENTUALLY CAUSE A STRESS FRACTURE. S
Summary:
THE LATCH PLATE USED IN THE SEAT BELT BUCKLE WAS NOT MANUFACTURED ACCORDING TO DESIGN DIMENSIONS. IF THE SEAT BELT TONGUE IS INSERTED SLOWLY AT AN ANGLE INTO THE BUCKLE, THERE IS A POSSIBILITY OF PARTIAL ENGAGEMENT.
Summary:
CONSTANT EXPANSION AND CONTRACTION OF THE CYLINDER HEAD CAUSES THE CAMSHAFT SEAL END PLUG CAN BECOME DISLODGED FROM THE CYLINDER HEAD. THIS ALLOWS OIL TO LEAK FROM THE CAMSHAFT.
Summary:
AN INTEGRATED CIRCUIT WITHIN THE VOLTAGE REGULATOR CAN CONTAIN MANUFACTURING ERRORS.