2005 Honda Pilot Problem Reports

Newest 2005 Honda Pilot Problem Reports

Report A Problem

Map light will not turn on when opening drivers or passengers door. Caused by a faulty door switch. Requires replacement of door switch on side of non operation.

The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.

A rough idle and harsh transmission shift can be caused by a broken front engine mount. Replacing the broken mount will address these issues.

An overheated wire in the head light harness can cause the low beams not to work. Replacing combination light/turn signal switch switch, the wire for the low beams, and the combination switch connector (if damaged) should repair this issue.

The engine may develop and oil leak due to a porous engine block casting. The repair procedure is dependent on where the leak is located. Honda has released a service bulletin covering model year 2003. Honda may offer assistance with repairs, determined on a case by case basis.

A chirp noise from the timing belt area can be caused by a tilted idler pulley. Installing a corrective shim from Honda will commonly correct this issue.

A knock or clunk type noise may be noted from the front suspension over bumps. This is can caused by worm stabilizer (sway) bar links. Replacing both stabilizer bar links will commonly repair this issue.

Noise and judder can develop from the rear axle due to differential fluid breakdown. Replacing the fluid will commonly correct this issue.

On certain models a leaking side marker light wire harness can cause a water leak inside the vehicle. Resealing the wire harness where it goes through the body into the cabin area should stop the leak.

On certain models the PCM misinterprets data from the coolant sensor and sets a false Check Engine light (MIL). A software update from Honda will repair this issue.