Rear vent windows not operating properly is a common problem with Honda Odesseys. The solution is to replace the window motors.
1995 Honda Odyssey Problem Reports
Newest 1995 Honda Odyssey Problem Reports
The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.
A rear engine mount that is broken can cause an engine vibration felt in the vehicle. Replacing the failed mount will repair this problem.
On certain models the fuel gauge will not read full due to excessive resistance in the sending unit. Replacing the sending unit in the fuel tank will commonly repair this issue.
A seal in the 4 cylinder engine around the balance shaft tends to fall out, causing a large oil leak. There is a retaining device available to prevent the seal from falling out, which can be put in place during routine timing belt maintenance.
A refrigerant leak may develop from the AC evaporator causing the AC to blow warm air. Verifying failure of this component is difficult. A good shop will use leak detection dye to verify a failing evaporator.
The AC evaporator drain can clog and cause a water leak inside the vehicle, usually on the passenger floor. Cleaning the drain will fix this problem.
Damaged engine mounts can lead to vibration and roughness felt in the steering wheel. A rattle in the dash and engine area may also be heard. Replacement of damaged mounts will commonly correct these issues.
The clock light has a tendency to burn out.
There is an issue where the transmission can have a torque converter problem, or the computer monitoring the torque converter can misinterpret the information, and in either case this can cause the Check Engine Light (MIL) to illuminate. The problem will need to be diagnosed and depending upon what is causing the issue, the transmission will have to be repaired or the computer replaced.
On certain models moisture can get into the rear wheel bearing and cause a noise. Replacing the rear wheel bearing is needed for this issue.