2005 Honda CR-V Problems

RepairPal has identified the most common problems with the 2005 Honda CR-V as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
22
Known Problems

On certain models a faulty windshield wiper motor can cause the wipers not to turn off or not park properly. The wiper motor needs to be replaced to address this issue.

Worn door lock tumblers can cause the door lock to be sticky or not work at all. The lock has to be removed and the tumblers need to be replaced for this issue.

The AC compressor may seize resulting in loss of cold air from the AC vents. Often when the compressor fails in the fashion, debris is spread through out the entire air conditioning system resulting in very expensive repairs.

A binding fuel filler cap can cause the Check Engine Light to illuminate. Our technicians tell us this can be caused by a problem with the fuel filler neck which may require replacement.

A faulty transmission range switch can cause a no start condition and  Check Engine light (MIL) illumination. Transmission removal is not needed to replace the transmission range switch.

A sticking intake manifold runner solenoid can cause the Check Engine light (MIL) to illuminate. Replacing the solenoid will repair the issue.

A defect in the throttle body can cause the Check Engine light (MIL) to illuminate. Replacing the throttle body will repair this issue.

A maladjusted tailgate or tailgate switch can cause the rear tailgate light on the dash to flicker when driving. Adjusting the door and or switch will address this concern.

Some vehicles with an automatic transmission can have an issue with a harsh shift from first to second gear. Honda has released a service bulletin suggesting to flush the transmission using Honda ATF-Z1 and replace the linear solenoid. If that does not cure the problem the fault is internal and the transmission will require replacement or overhaul.

The rear trailing arm bushings tend to crack and break requiring replacement of the bushings.

On certain models with rear disc brakes, a grinding noise can be caused by corrosion between the rear brake caliper bracket and the brake pad retainers. Cleaning and lubricating the caliper bracket and pad retainers should correct this concern.

The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.

A groaning noise from the rear differential heard while going through turns can be caused by differential fluid break down. Servicing the rear differential will generally correct this concern.

On certain models the water pump bearing can go bad and cause a growl type noise from the front of the engine.