2000 Honda CR-V Problem Reports

RepairPal Verified 2000 Honda CR-V Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

A binding fuel filler cap can cause the Check Engine Light to illuminate. Our technicians tell us this can be caused by a problem with the fuel filler neck which may require replacement.

A faulty brake master cylinder reservoir filter can cause the brake system indicator to illuminate after a cold start and then go off. Replacement of the reservoir filter will commonly fix this problem.

The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.

Some vehicles with an automatic transmission can have an issue with a harsh shift from first to second gear. Honda has released a service bulletin suggesting to flush the transmission using Honda ATF-Z1 and replace the linear solenoid. If that does not cure the problem the fault is internal and the transmission will require replacement or overhaul.

On certain models the water pump bearing can go bad and cause a growl type noise from the front of the engine.

 

The engine valves can prematurely fail. The cylinder head will need to be replaced due to wear in the area where the valves seal. Intake or exhaust valve failure may illuminate the Check Engine Light. The car may have poor engine performance and fail emission tests.

A groaning noise from the rear differential heard while going through turns can be caused by differential fluid break down. Servicing the rear differential will generally correct this concern.

The rear trailing arm bushings tend to crack and break requiring replacement of the bushings.

A leaking cowl (at the base of the windshield) can leak water into the vehicle's cabin. The cowl has to be resealed to stop the leak.