A worn speed sensor drive gear can cause a surge when using cruise control and illuminate the Check Engine light. Transmission replacement will be needed.
Problems for specific Honda CR-V years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1997 Honda CR-V problems
The AC compressor may seize resulting in loss of cold air from the AC vents. Often when the compressor fails in the fashion, debris is spread through out the entire air conditioning system resulting in very expensive repairs.
A faulty brake master cylinder reservoir filter can cause the brake system indicator to illuminate after a cold start and then go off. Replacement of the reservoir filter will commonly fix this problem.
The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.
Some vehicles with an automatic transmission can have an issue with a harsh shift from first to second gear. Honda has released a service bulletin suggesting to flush the transmission using Honda ATF-Z1 and replace the linear solenoid. If that does not cure the problem the fault is internal and the transmission will require replacement or overhaul.
On certain models a faulty radiator fan motor can cause the AC not to cool properly. Replacing the faulty motor should correct this problem.
The AC idler pulley can fail causing a growling noise from the engine. A new idler pulley will be needed.
The engine valves can prematurely fail. The cylinder head will need to be replaced due to wear in the area where the valves seal. Intake or exhaust valve failure may illuminate the Check Engine Light. The car may have poor engine performance and fail emission tests.
A groaning noise from the rear differential heard while going through turns can be caused by differential fluid break down. Servicing the rear differential will generally correct this concern.
A clunking noise heard from the front suspension may be caused by the flange bolts for the upper control arm.
On certain models a faulty windshield wiper motor can cause the wipers not to turn off or not park properly. The wiper motor needs to be replaced to address this issue.