2007 Honda Accord Problem Reports

Newest 2007 Honda Accord Problem Reports

Report A Problem

My radio pops then speakers go off butradio is still on and all power Windows out except drivers you can hear them clicking but they don't work and a/c is blowing hot air

The computer can misinterpret a low battery voltage and can cause a false Check Engine (MIL) light to come on. Updating the PCM can correct this issue.

The PCM can misinterpret misfire data and set a false Check Engine (MIL) light requiring a PCM update to repair.

The AC condenser failed due to contact with road debris and a lack of protection for the condenser.

The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.

The ABS modulator (hydraulic unit) can leak air into the brake system and cause a low brake pedal. A new ABS modulator will be needed if it is diagnosed to be the source of the leak.

Ignition switch failure may cause the car to stall or fail to start. Honda issued a recall to replace the ignition switch. For more information on this recall please click here»

A chirping noise coming from the timing belt area can be caused by a misaligned, or tilted idler pulley.

If the brake pedal feels hard the first time it is pressed in the morning, it could be due to a problem with the vacuum supply hose for the brake booster. A revised brake booster hose is available to address this concern.

Plugged moon roof drains can cause a water leak inside the car. The water will usually leak onto the driver's or passenger's head when the car turns a corner.

On some models a mis-manufactured AC evaporator core can cause the AC to cool poorly. The AC evaporator needs to be replaced for the AC to cool properly.

The clock light has a tendency to burn out.

A water leak on the passenger floor can be caused by a clogged AC evaporator drain.

Power door locks can activate intermittently due to a faulty door lock actuator in the driver's door.

The air/fuel sensor, located in the exhaust system, may be damaged by moisture in the exhaust resulting in illumination of the Check Engine Light. Replacing the damaged air/fuel sensor and updating the powertrain control module (PCM) software should correct this concern.