A faulty Electric Load Detector (ELD) can cause the head lights to dim and/or illuminate the Check Engine Light. A failed ELD will require replacement.
Problems for specific Honda Accord years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2005 Honda Accord problems
The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.
Automatic transmission failures are common, Automatic transmission failure on these vehicles will generally require overhaul or replacement of the transmission. In the event of a failure, it may be worthwhile to check with Honda to see if they may offer assistance for this repair. As these vehicles age, Honda has become less likely to help out with these transmission related repairs.
I had my wheel bearings replaced at Honda dealer right before it warranty deadline at 35870 miles.
It went noisy, and both were replaced at 36K by a dealer under warranty.
Just wanted to express disappointment with the car at such low mile marker.
Got it done for free just a hundred miles before the end of the warranty.
I have no solution other that to go to a shop to replace them ( both in this case )
One or both of the rear sway bar end links may break resulting in a knocking noise from the rear of the vehicle.
The ABS modulator (hydraulic unit) can leak air into the brake system and cause a low brake pedal. A new ABS modulator will be needed if it is diagnosed to be the source of the leak.
Honda issued a recall on some 2005 Accord models due to a defective fuel pump relay. If the fuel pump relay fails, the car will stall or fail to start. For more information on this recall please click here»
If the brake pedal feels hard the first time it is pressed in the morning, it could be due to a problem with the vacuum supply hose for the brake booster. A revised brake booster hose is available to address this concern.
Plugged moon roof drains can cause a water leak inside the car. The water will usually leak onto the driver's or passenger's head when the car turns a corner.
The driver's door latch assembly can break internally, which causes the door to stay closed. The interior and exterior door handles do not work to open the door. Our technicians note that the door panel must be removed while the door is closed (likely damage will occur) and the latch assembly must be drilled in a specific spot for the door to open.
Power door locks can activate intermittently due to a faulty door lock actuator in the driver's door.
The AC condenser failed due to contact with road debris and a lack of protection for the condenser.
Front compliance (lower control arm ) bushings tend to crack and break requiring replacement.