2002 Honda Accord Problem Reports
Newest 2002 Honda Accord Problem Reports
A Check Engine Light can come on because some models may misinterpret the ratio of air and fuel being burned for combustion. The powertrain control module (PCM) will need to be replaced to fix the problem.
A faulty brake master cylinder reservoir filter can cause the brake system indicator to illuminate after a cold start and then go off. Replacement of the reservoir filter will commonly fix this problem.
The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.
A rough idle and harsh transmission shift can be caused by a broken front engine mount. Replacing the broken mount will address these issues.
Automatic transmission failures are common, Automatic transmission failure on these vehicles will generally require overhaul or replacement of the transmission. In the event of a failure, it may be worthwhile to check with Honda to see if they may offer assistance for this repair. As these vehicles age, Honda has become less likely to help out with these transmission related repairs.
One or both of the rear sway bar end links may break resulting in a knocking noise from the rear of the vehicle.
The engine may develop and oil leak due to a porous engine block casting. The repair procedure is dependent on where the leak is located. Honda has released a service bulletin covering model years 1998-2003. Honda may offer assistance with repairs, determined on a case by case basis.
If the brake pedal feels hard the first time it is pressed in the morning, it could be due to a problem with the vacuum supply hose for the brake booster. A revised brake booster hose is available to address this concern.
Plugged moon roof drains can cause a water leak inside the car. The water will usually leak onto the driver's or passenger's head when the car turns a corner.
The throttle body can accumulate carbon deposits causing the throttle to stick or pop when first accelerating after the vehicle sits for a while. Performing a throttle body service will generally correct this problem.
Damaged engine mounts can lead to vibration and roughness felt in the steering wheel. A rattle in the dash and engine area may also be heard. Replacement of damaged mounts will commonly correct these issues.
The driver's door latch assembly can break internally, which causes the door to stay closed. The interior and exterior door handles do not work to open the door. Our technicians note that the door panel must be removed while the door is closed (likely damage will occur) and the latch assembly must be drilled in a specific spot for the door to open.
Power door locks can activate intermittently due to a faulty door lock actuator in the driver's door.