2001 Honda Accord Problem Reports

RepairPal Verified 2001 Honda Accord Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

A Check Engine light can come on if the EGR ports have clogged. The P0401 code may be set as well.

A Check Engine Light may illuminate if the EGR ports have clogged or if the catalyst inside the catalytic converter has deteriorated.

A faulty brake master cylinder reservoir filter can cause the brake system indicator to illuminate after a cold start and then go off. Replacement of the reservoir filter will commonly fix this problem.

The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.

A rough idle and harsh transmission shift can be caused by a broken front engine mount. Replacing the broken mount will address these issues.

Automatic transmission failures are common, Automatic transmission failure on these vehicles will generally require overhaul or replacement of the transmission. In the event of a  failure, it may be worthwhile to check with Honda to see if they may offer assistance for this repair. As these vehicles age, Honda has become less likely to help out with these transmission related repairs.

One or both of the rear sway bar end links may break resulting in a knocking noise from the rear of the vehicle.

Ignition switch failure may cause the car to stall or fail to start. Honda issued a recall to replace the ignition switch. For more information on this recall please click here»

The engine may develop and oil leak due to a porous engine block casting. The repair procedure is dependent on where the leak is located. Honda has released a service bulletin covering model years 1998-2003. Honda may offer assistance with repairs, determined on a case by case basis.

Plugged moon roof drains can cause a water leak inside the car. The water will usually leak onto the driver's or passenger's head when the car turns a corner.

The clock light has a tendency to burn out.

The throttle body can accumulate carbon deposits causing the throttle to stick or pop when first accelerating after the vehicle sits for a while. Performing a throttle body service will generally correct this problem.

Damaged engine mounts can lead to vibration and roughness felt in the steering wheel. A rattle in the dash and engine area may also be heard. Replacement of damaged mounts will commonly correct these issues.

The driver's door latch assembly can break internally, which causes the door to stay closed. The interior and exterior door handles do not work to open the door. Our technicians note that the door panel must be removed while the door is closed (likely damage will occur) and the latch assembly must be drilled in a specific spot for the door to open.

Front compliance (lower control arm ) bushings tend to crack and break requiring replacement.