Transmission Control Unit/Module(TCU/TCM) for Honda models 1992-1994, were made with faulty components. I knew mine was bad, not only through my research efforts, but also because I took the TCU completely apart so that I could visually inspect the circuit board. That was when I discovered a burnt spot on one of the components. The Transmission Control Module is located under the carpeting of the floorboard on the passenger side. First disconn...
Problems for specific Honda Accord years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1992 Honda Accord problems
The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.
Automatic transmission failures are common, Automatic transmission failure on these vehicles will generally require overhaul or replacement of the transmission. In the event of a failure, it may be worthwhile to check with Honda to see if they may offer assistance for this repair. As these vehicles age, Honda has become less likely to help out with these transmission related repairs.
Head gasket failure is not uncommon if the engine overheats. If the temperature climbs above the normal operating temperature, turn the heater on the hottest setting, pull over to a safe location, and shut the engine off to allow the engine to cool down.
Plugged moon roof drains can cause a water leak inside the car. The water will usually leak onto the driver's or passenger's head when the car turns a corner.
Damaged engine mounts can lead to vibration and roughness felt in the steering wheel. A rattle in the dash and engine area may also be heard. Replacement of damaged mounts will commonly correct these issues.
The driver's door latch assembly can break internally, which causes the door to stay closed. The interior and exterior door handles do not work to open the door. Our technicians note that the door panel must be removed while the door is closed (likely damage will occur) and the latch assembly must be drilled in a specific spot for the door to open.
Power door locks can activate intermittently due to a faulty door lock actuator in the driver's door.
The temperature control knob may break, requiring replacement.
Leaking gaskets around the tail lights can allow water entry into the tail light assembly. New gaskets should fix this concern.
An oil leak inside the distributor can cause the engine to misfire resulting in a loss of power. It is common for the distributor to be replaced to correct this concern.
On some models moisture could make its way into the rear wheel bearing, which would lead to noise. Rear wheel bearing and dust cap replacement will be needed for this repair.