1991 Honda Accord Problem Reports

Newest 1991 Honda Accord Problem Reports

Report A Problem

A Check Engine Light may illuminate if the EGR ports have clogged or if the catalyst inside the catalytic converter has deteriorated.

The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.

Head gasket failure is not uncommon if the engine overheats. If the temperature climbs above the normal operating temperature, turn the heater on the hottest setting, pull over to a safe location, and shut the engine off to allow the engine to cool down.

Plugged moon roof drains can cause a water leak inside the car. The water will usually leak onto the driver's or passenger's head when the car turns a corner.

Some models have problems with alternator bearing failures.

Damaged engine mounts can lead to vibration and roughness felt in the steering wheel. A rattle in the dash and engine area may also be heard. Replacement of damaged mounts will commonly correct these issues.

The driver's door latch assembly can break internally, which causes the door to stay closed. The interior and exterior door handles do not work to open the door. Our technicians note that the door panel must be removed while the door is closed (likely damage will occur) and the latch assembly must be drilled in a specific spot for the door to open.

Power door locks can activate intermittently due to a faulty door lock actuator in the driver's door.

The temperature control knob may break, requiring replacement.

Leaking gaskets around the tail lights can allow water entry into the tail light assembly. New gaskets should fix this concern.

The distributors on higher mileage vehicles can leak oil onto the heater hose causing the hose to soften and break. Heater hose breakage will cause a coolant leak.

Some models have shift quality problems when shifting into third gear. A new "third gear set" from Honda will address this issue.

An oil leak inside the distributor can cause the engine to misfire resulting in a loss of power. It is common for the distributor to be replaced to correct this concern.

On some models moisture could make its way into the rear wheel bearing, which would lead to noise. Rear wheel bearing and dust cap replacement will be needed for this repair.

Some models can leak engine oil from the camshaft seal.