Q&A

 Master

CONCORDE/300M
Release hood latch and open hood.
Disconnect and isolate the battery negative remote cable.
Remove the one bolt retaining the washer bottle filler neck and move aside.
Remove the two bolts retaining the speed control servo and move aside.
Remove fasteners to upper radiator crossmember:
Two jack screws on each side.
Three crossmember retaining bolts on each side.
Three push pin fasteners across top of grille.
Gently pry back grille and remove the two bolts to front crossmember. This will allow you to move the crossmember forward, pivoting at the radiator grille, to access the headlamp unit.
NOTE: Once the crossmember is loose, take care not to scratch the fenders.

Maneuver the headlamp unit to remove from behind fascia. Gentle prying of fascia may be needed to clear it enough to remove the headlamp unit.
Disconnect the lamp connectors and transfer lamps if replacing unit.
INTREPID
Release hood latch and open hood.
Disconnect and isolate the battery negative cable.
Remove jackscrews attaching headlamp to body (Headlamp Housing – Intrepid).
Remove headlamp from body.
Disconnect wire connector from headlamp and parking, side marker, and turn signal lamps.
Remove headlamp housing from vehicle.