The ignition switch actuator can bind causing the ignition switch to stick in the "start" position. If this were to occur the actuator can unexpectedly release, cause the ignition switch to snap back into the "Accessory" position. This would cause the engine to turn off with an associated loss of brake and steering power assist. If these conditions were to lead to a crash the airbags may not deploy as expected. Dealers will inspect and replace the ignition lock housing as necessary to correct this concern.
GMC Yukon XL 2500 Recalls
The chassis electrical module can short due to internal contamination. This can result in the vehicle stalling. Dealers will replace the chassis electronic module free of charge to resolve the concern.
All late model vehicles are equipped with a "Shift interlock" system that prevents vehicles with and automatic transmission from being shifted out of the Park position under certain conditions. Some of these vehicles are being recalled because they may have been assembled with a broken park lock cable or a malformed steering column lock actuator gear. Failure of these components can allow the shifter to be moved out of the Park position with the ignition key removed or in the off position. This can cause the vehicle to roll away unexpectedly increasing the risk of injury or a crash. Dealers will inspect the recalled vehicles and replace the steering column as necessary.
The steering gear pitman shaft may not have been adequately hardened and could break. If this occurs, a loss of steering ability will result, increasing the risk of a crash. Dealers will inspect the steering gear and replace the steering gear pitman shaft if necessary to correct this concern. The General Motors recall number is 12005.
The heated washer module under the hood could overheat due to excessive current draw. Under certain conditions, this could result in an under hood fire. This previous recall attempt in 2008 to repair this concern did not have the expected success. Dealers will now permanently disable and remove the heated washer module to correct this concern. This recall is expected to begin on June 20, 2010.
The RTV seal on the fuel system control modules may allow water to enter into the module. Water in the module can cause a short, which may cause hard starting, a crank-no start condition, or stalling, and the Service Engine Soon light may come on. If the engine stalls unexpectedly, there is an increased risk of a crash. Dealers will replace the fuel system control module free of charge. The recall began on May 18, 2009. The GM recall number is 08411.
The wiring to the washer system heater may overheat due to a failure in the heater module. This could cause other electrical features to malfunction, smoke to develop, and an electrical fire could result. Dealers will install a wire harness with an inline fuse to protect the washer heater module. This recall is expected to begin on September 12, 2008. The General Motors recall number is 08048.
The retainer clip for the fuel rail pulse damper may fracture and allow the damper to come loose from the fuel rail. A fuel leak in the presence of an ignition source may result in a fire. Dealers will replace the engine fuel rail pulse damper free of charge. The recall began August 31, 2006. The GM recall number is 06080.
The tire and loading information label on the driver's side door frame may be inaccurate. A misprinted label could lead to overloading of the vehicle, which could possibly lead to tire failure and a crash. Owners will be provided with corrected labels and installation instructions. At customers' request, a dealer can install the label for them. The recall began March 31, 2006. The GM recall number is 05109.
The wiring to the fuel pump may overheat, which may cause multiple concerns. The fuse for the pump may blow, which will prevent the vehicle from starting and running. A check engine light may come on from connector damage. Fuel may leak out of the connector body and create a fire hazard. Dealers will remove the fuel tank and remove the module reservoir assemblies from the fuel tank, and install a new service kit.