The ignition switch actuator can bind causing the ignition switch to stick in the "start" position. If this were to occur the actuator can unexpectedly release, cause the ignition switch to snap back into the "Accessory" position. This would cause the engine to turn off with an associated loss of brake and steering power assist. If these conditions were to lead to a crash the airbags may not deploy as expected. Dealers will inspect and replace the ignition lock housing as necessary to correct this concern.
GMC Sierra 1500 Hybrid Recalls
All late model vehicles are equipped with a "Shift interlock" system that prevents vehicles with and automatic transmission from being shifted out of the Park position under certain conditions. Some of these vehicles are being recalled because they may have been assembled with a broken park lock cable or a malformed steering column lock actuator gear. Failure of these components can allow the shifter to be moved out of the Park position with the ignition key removed or in the off position. This can cause the vehicle to roll away unexpectedly increasing the risk of injury or a crash. Dealers will inspect the recalled vehicles and replace the steering column as necessary.
The heated washer module under the hood could overheat due to excessive current draw. Under certain conditions, this could result in an under hood fire. This previous recall attempt in 2008 to repair this concern did not have the expected success. Dealers will now permanently disable and remove the heated washer module to correct this concern. This recall is expected to begin on June 20, 2010.
The wiring to the washer system heater may overheat due to a failure in the heater module. This could cause other electrical features to malfunction, smoke to develop, and an electrical fire could result. Dealers will install a wire harness with an inline fuse to protect the washer heater module. This recall is expected to begin on September 12, 2008. The General Motors recall number is 08048.