The ignition switch actuator can bind causing the ignition switch to stick in the "start" position. If this were to occur the actuator can unexpectedly release, cause the ignition switch to snap back into the "Accessory" position. This would cause the engine to turn off with an associated loss of brake and steering power assist. If these conditions were to lead to a crash the airbags may not deploy as expected. Dealers will inspect and replace the ignition lock housing as necessary to correct this concern.
Certain trucks are being recalled because the rear axle shaft may not have been properly heat treated prior to vehicle assembly and could fail while driving. If this were to occur a rear wheel could separate from the vehicle, increasing the risk of a crash. Dealers will inspect and replace the affected axles to correct this concern.
These vehicles are being recalled because the headlamp driver module (HDM) can overheat and fail. This will cause the headlights and daytime running lights to stop working. Loss of this lighting will affect the ability of the driver to see the road and reduce the vehicle's visibility to oncoming vehicles, both of which increase the risk of a vehicle crash. The remedy for this problem is still under development and not yet available.
A fault can develop with the Electric Power Steering resulting in sudden loss of power steering assist, increasing the risk of a crash. Dealers will replace the power steering assist motor kit to correct this concern.
The chassis electrical module can short due to internal contamination. This can result in the vehicle stalling. Dealers will replace the chassis electronic module free of charge to resolve the concern.
Certain vehicles equipped to run on compressed natural gas are being recalled because the high pressure natural gas regulator could develop a leak, increasing the risk of a fire or explosion. Dealers will replace the natural gas regulator to correct this concern.
The driver's and/or passenger's seat may suddenly drop to its lowest position because a bolt securing the height adjuster can fall out. This unexpected movement of the driver's seat could cause a distraction, increasing the risk of a crash. Dealers will replace the height adjuster bolts in both front seats to correct this concern.
In the affected vehicles, there is a flexible steel steel cable that connects the seatbelt buckle to the front seat frame. Over time the cable may fatigue and separate. If the steel cable separates, the seatbelt may not properly restrain the seat occupant, increasing the risk of an injury in a crash. Dealers will inspect and replace the affected seatbelt buckles (lap pretensioners) to correct this concern.
Increased resistance in the front seat mounted side impact air bag (SIAB) wiring harness can result in the SIAB and seat belt pretensioners not deploying as expected in the event of a crash, increasing the risk of personal injury. Dealers will replace the affected harness connections with soldered connections to correct this concern.
Certain vehicles are being recalled because if a crash were to occur not requiring deployment of the front airbags, the head of an unbelted front seat passenger could hit the instrument panel, resulting in personal injury because the panel may not sufficiently absorb the impact. As of this writing, General Motors is still working on a remedy for this concern.