» » »

Problems for specific GMC Yukon XL 2500 years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Repairpal verified 2000 GMC Yukon XL 2500 problems

 

Verified for the GMC Yukon XL 2500

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

9 Reports
Me Too

Verified for the GMC Yukon XL 2500

The inside door handles are prone to breaking.

3 Reports
Me Too

Verified for the GMC Yukon XL 2500

The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.

8 Reports
Me Too

Verified for the GMC Yukon XL 2500

Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.

2 Reports
Me Too

Verified for the GMC Yukon XL 2500

A rattling noise may develop from the AC belt tensioner. This can be caused by an internal fault with the AC compressor, AC performance may also be diminished when this occurs. Our technicians tell us that replacing the ac compressor will commonly correct this concern.

3 Reports
Me Too

Verified for the GMC Yukon XL 2500

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

6 Reports
Me Too

Verified for the GMC Yukon XL 2500

One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.

7 Reports
Me Too

Verified for the GMC Yukon XL 2500

A clicking noise may be noted from the turn signal flasher after the turn signals are switched off.  This is commonly cause by a faulty turn signal switch which will require replacement.

12 Reports
Me Too

Verified for the GMC Yukon XL 2500

The battery may leak acid at the battery cable connections. As a result corrosion may form on the battery cable ends. Leaking batteries should be replaced and the cables need to be thoroughly cleaned or replaced if necessary.

4 Reports
Me Too

Verified for the GMC Yukon XL 2500

The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 2000-2003 models is #4114K (trade number).

7 Reports
Me Too

Verified for the GMC Yukon XL 2500

The anti-lock brake system (ABS) pump may stay running after the ignition is turned off causing the battery to go dead. Our technicians tell us that the ABS control module should be replaced to correct this fault.

6 Reports
Me Too

Verified for the GMC Yukon XL 2500

Units with 4 wheel disk brakes may develop at situation where the park brake does not hold as it should. Our technicians tell us this can be caused by worn park brake shoes located inside the drum section of the rear brake disks. The worn shoes should be replaced and properly adjusted to correct this issue.

7 Reports
Me Too

Verified for the GMC Yukon XL 2500

The sunroof may stop working for various different reasons. Our technicians tell us it is often better to replace the complete sunroof assembly than to try and repair the old one.

7 Reports
Me Too

Verified for the GMC Yukon XL 2500

A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.

7 Reports
Me Too

Verified for the GMC Yukon XL 2500

The CD player may fail due to an internal fault with the radio. Our technicians tell us that in most cases, the radio unit will need to be sent to a specialty repair shop to correct this issue.

4 Reports
Me Too
Ask a Question