Problem with your car? See what our experts say or submit your own.
2000 GMC Yukon Denali Problems
A Loose or worn gas cap may cause Check Engine Light to illuminate.
The front or rear differential may develop an abnormal noise due to worn bearings or another internal fault. Our technicians tell us that a complete overhaul of the affected differential is commonly necessary to correct this condition.
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.
Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.
Power brake systems using "hydro-boost" may leak power steering fluid from the hydro-boost unit located behind the brake master cylinder. Replacement of the hydro-boost unit is the common repair to correct this concern.
One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.
A clicking noise may be noted from the turn signal flasher after the turn signals are switched off. This is commonly cause by a faulty turn signal switch which will require replacement.
The quick-connect fittings for the heater hoses tend to leak engine coolant. This problem commonly occurs because the metal housing has become brittle, which can break and cause leaks.
The air conditioning compressor may develop an abnormal noise and require replacement. We recommend that whenever an AC compressor is being replaced for a noise condition, a filter kit should be installed to prevent any metal particles in the system from damaging the new compressor.
The power door lock actuators may become slow to operate or stop working completely and require replacement.
A coolant leak may develop from the water pump. This can result in an engine overheating condition. A leaking water pump will require replacement.
The windshield wipers may not work intermittently due to a faulty wiper motor control board. Our technicians tell us that lightly taping on the wiper motor when the fault occurs should temporarily get the wipers working again. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.