2007 GMC Yukon Problems
RepairPal has identified the most common problems with the 2007 GMC Yukon as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The power door lock actuators may become slow to operate or stop working completely and require replacement.
The upper dash may crack, most commonly on vehicles in warm climates and exposed to a lot of sunlight. The common repair is to replace the upper instrument trim panel. Information on a technical service bulletin or extended warranty is not available at this time.
The inside and outside door handles are prone to breaking.
The 2004-2007 Yukon is known to have issues with the EVAP system, a part of your emission control system.
To correct the issue, the EVAP canister vent valve, solenoid, and wiring must be inspected. The most common fix is replacement of the wiring connector or replacement of the vent valve assembly.
The rear window defogger may stop working due to a wire terminal broken off of the rear glass. Our technicians tell us that terminal can be reattached using a special glue or silver solder.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault. The warranty has been extended on some of these units to 7 years or 70,000 miles.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
One or more fuel injectors may become stuck closed causing an engine misfire and the Check Engine Light to illuminate. Our technicians tell us that this problem can be caused by some fuel additives. There are special procedures which may be able to restore the affected injector. If this fails the affected injector must be replaced.
The keyless entry system may stop working. Our technicians tell us the key fobs and keyless entry receiver may need to be replaced to correct this fault.