1997 GMC Yukon Questions
Answered 1997 GMC Yukon Questions
Ask a Question
Hear a banging noise when going over speed bumps or pot holes on front left. Shakes under braking, worse between 40-50 mph. And alignment off but just had it done at a shop and wheels balanced?
Should there be resistance on the ic wire from pcm to icm? And if so how much? And if not, what would couse there to be?
97 yukon 5.7l starts then dies right away, have spark and fuel and timed
Under hard acceleration spits n sputter s
the head gasket is blown in the 1997 yukon and i found a 1996 with a good motor will i be able to put the motor in the 97 ?
It does not blow any cool air at all. the vent door will not close when going from heat to air conditioner
so i changed the spark plugs it ran good for a couple miles and went straight back to sputtering during acceleration
replaced rotor cap plugs wires o2sensors mass airflow sensor and still getting code p0306 and it has a distributor and a throttle body, so what now
this model has throttle body and distributor high missfire when accelerating
I checked all fuses, replaced the headlight switch what else could it be?
Last couple of days now, gage light will come on,water pressure running hot, but then will go back to normal,heater takes long to work.twice I had to add coolant.I checked for leaks,radiator,hoses, around engine,no le...
y 1997gmc 700r4 transmission wont go into gear at all not even park
How do I install a new rear window seal if I can find a replacement? Where do I find a new seal?
my lights go dim and then they get bright and go dim again
I've had my AC service and a lot of parts replaced. Now I'm told that something under the dash needs replacing and it will cost $1200. What ist it and can I reach it?
I have 1997 GMC yukon with 260,000 miles on it. I was headed to school the other day, and as I accelerated I heard a loud pop and my truck began to shimmy servilely. I got it home, started it up, and when I put it in ...