» » »

Problems for specific GMC Yukon years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Newest reported 1993 GMC Yukon problems

 

Verified for the GMC Yukon

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

5 Reports
Me Too

Verified for the GMC Yukon

The front or rear differential may develop an abnormal noise due to worn bearings or another internal fault. Our technicians tell us that a complete overhaul of the affected differential is commonly necessary to correct this condition.

7 Reports
Me Too

Verified for the GMC Yukon

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.

16 Reports
Me Too

Verified for the GMC Yukon

The valve cover gaskets may develop engine oil leaks.

2 Reports
Me Too

Verified for the GMC Yukon

Power brake systems using "hydro-boost" may leak power steering fluid from the hydro-boost unit located behind the brake master cylinder. Replacement of the hydro-boost unit is the common repair to correct this concern.

10 Reports
Me Too

Verified for the GMC Yukon

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

4 Reports
Me Too

Verified for the GMC Yukon

The quick-connect fittings for the heater hoses tend to leak engine coolant. This problem commonly occurs because the metal housing has become brittle, which can break and cause leaks.

13 Reports
Me Too

Verified for the GMC Yukon

The air conditioning compressor may develop an abnormal noise and require replacement. We recommend that whenever an AC compressor is being replaced for a noise condition, a filter kit should be installed to prevent any metal particles in the system from damaging the new compressor.

8 Reports
Me Too

Verified for the GMC Yukon

The power door lock actuators may become slow to operate or stop working completely and require replacement.

52 Reports
Me Too

Verified for the GMC Yukon

The anti-lock brake system (ABS) front wheel speed sensors are prone to failure. When a sensor fails, the ABS warning light may illuminate and/or the ABS system may activate erratically.

30 Reports
Me Too

Verified for the GMC Yukon

An engine vacuum leak may develop from the throttle body gasket causing a higher than normal idle speed. Failed gaskets should be replaced.

4 Reports
Me Too

Verified for the GMC Yukon

A coolant leak may develop from the water pump. This can result in an engine overheating condition. A leaking water pump will require replacement.

17 Reports
Me Too

Verified for the GMC Yukon

The windshield wipers may not work intermittently due to a faulty wiper motor control board. Our technicians tell us that lightly taping on the wiper motor when the fault occurs should temporarily get the wipers working again. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.

12 Reports
Me Too

Verified for the GMC Yukon

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

17 Reports
Me Too

Verified for the GMC Yukon

The inside and outside door handles are prone to breaking.

30 Reports
Me Too
Ask a Question