1993 GMC Sonoma Questions

Answered 1993 GMC Sonoma Questions

Ask a Question
View:RecentAnsweredUnanswered
While in the shop they replaced my distributor, dist cap, rotor button, coil, plugwires, starter and intake manifold gasket.
I have replaced the throttle body and need to verify engine speed
it doesnt happen a lot i forgot to check the fluid
Checking for codes came up with code 43 what else can I do to fix it
it is on a 93 gmc sonoma i am in the the proses of replacing the heater core and was wondering why the A.C compresser was frosted over after driveing but not useing the ac
My 4WD decided to stop working on my truck. I had a mechanic tell me that it's probably the actuator, so I would like to replace it myself to save some money(the part is like $50 at Autozone). I've been looking online...
i replace the slave cylinder the truck is strating but not going into gear i tried bleeding the slave cylinder but its still loose
going down road @55,60 mph starts missing will not throttle unless u mash to floor takes out good when back to cruze speed no power again. will run great @ full throttle
Problems with driver rear brake light and turning signal. The wiring is old and has some burnt wires, have replaced fuses and bulbs. What is the best way to fix this problem
how to remove dashboard on 1993 gmc sonoma with picture thanks ray
The running lights do not work anymore and I have checked all the fuses and wires.
erg valve has been checked ,just had new clutch pressure plate and tune up done in jan 29th,was runnin fine till recently ,made two trips to sc everything was fine now high idle spittin sputterin doesnt seem to want ...