2006 GMC Sierra 1500 HD Problems
RepairPal has identified the most common problems with the 2006 GMC Sierra 1500 HD based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The GMC Sierra 1500 HD is known to have issues with the EVAP system, a part of your emission control system.
To correct the issue, the EVAP canister vent valve, solenoid, and wiring must be inspected. The most common fix is replacement of the wiring connector or replacement of the vent valve assembly.
The headlight switch used on the GMC Sierra 1500 HD is known to fail through normal operation. Since the headlight switch is also integrated into the interior lights, a malfunctioning switch can cause issues with interior lights as well.
- Symptoms of a failed headlight switch include:
- Headlights and taillights failing to turn on or off
- Interior lights flicker, or fail to turn on or off
- Gauge cluster lighting off or flickering with headlights on
- Parking light malfunctions
This issue is well known with General Motors Trucks and SUVs, and is solved by testing and, if needed, replacing the headlight/dimmer switch. Bad grounding wires at the tail-lights, and dirty/corroded tow package wires can also lead to some of these issues.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
The fuel pump may fail causing the engine to stall and not restart.
The muffler heat shield may become loose on the muffler causing a rattle or popping noise. Our technicians tell us there is a kit available from GM to correct this problem.
A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground on the frame rail below the drivers door may be necessary.
One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.
A clicking noise may be noted from the turn signal flasher after the turn signals are switched off. This is commonly cause by a faulty turn signal switch which will require replacement.
The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 2001-2003 models is #4114K (trade number).
Units with 4 wheel disk brakes may develop at situation where the park brake does not hold as it should. Our technicians tell us this can be caused by worn park brake shoes located inside the drum section of the rear brake disks. The worn shoes should be replaced and properly adjusted to correct this issue.