Q&A

I have changed MAF and O2 Sensor. Blew cigar smoke into booster hose into intake to area to detec...

I replaced the blend door motor on my 98 jimmy and when I plug it it and watching it before I put...

I also flushed the heater core and both hose get hot so not clogged, but still blows cold air, ca...

Monkey wrenchs hammer sockets extensions screwdrivers alt. off compres brack is off I'm tier...

it will shift into 4wd hi when slowing down from hwy speeds to under 45 mph. I then have to pull ...

Lights stay on , then when I put the turn signal on they all stay on but not flashing

Changed plugs . Very hard to start at times , when I get it started it idles well but when I get ...

also makes a hydraulic noise and the brakes dont work, when you push really hard they will work a...

now my car is stalling and will not start ...what can i do now to get my truck running ....need h...

I have already changed wheel bearings,master cylinder,calipers,and I also changed brakes hoses 2 ...

treaded ? Book says hold pump pulley then remove ,but how?
thanks for HELP!!!

I did replace the tie rod ends but does not seem to help

HAVE CHARGED BATTERY AND CLEARED CODES STILL SAME / WHAT CAN I DO FROM HERE

Air flows to all areas when control knobs are turned. No change in air temp, heat is going to the...

That's what a Firestone dealer said. Also that if not done the wheels and/or engine could f...