1991 GMC Jimmy Problems
RepairPal has identified the most common problems with the 1991 GMC Jimmy as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
Our technicians highly recommend that the transmission is serviced every 30,000 miles to avoid problems and maintain optimal operating order.
For the 4L80-E Transmission only (Diesel engine), Transmission fluid may leak through the electrical connector on the side of the transmission, damaging the wire harness and causing the transmission to shift erratically. Our technicians tell us there are updated shift solenoids, an internal transmission harness, and a connector pigtail available to correct this fault.
The air conditioning compressor may develop an abnormal noise and require replacement. We recommend that whenever an AC compressor is being replaced for a noise condition, a filter kit should be installed to prevent any metal particles in the system from damaging the new compressor.
The throttle body gasket may develop a vacuum leak which may result in a higher than normal engine idle. Failed gaskets will require replacement.
A coolant leak may develop from the water pump. This can result in an engine overheating condition. A leaking water pump will require replacement.
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.
Power brake systems using "hydro-boost" may leak power steering fluid from the hydro-boost unit located behind the brake master cylinder. Replacement of the hydro-boost unit is the common repair to correct this concern.
The power door lock actuators may become slow to operate or stop working completely and require replacement.
The windshield wipers may not work intermittently due to a faulty wiper motor control board. Our technicians tell us that lightly taping on the wiper motor when the fault occurs should temporarily get the wipers working again. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.
The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.
The inside and outside door handles are prone to breaking.