i had this problem for a while( my personal vehicle). The truck would go into reduce engine power mode at first. Turn the engine off and restarts with no prblem. I ignored it just didn't use defrost or A/C. Than as time went on(months)it got cold here in Philly and i needed my defrost.This time the truck shut off. turned off defrost and it started right up and ran normal. i looked for vacuum leaks. not many hoses to check. finally found advic...
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2007 GMC Envoy problems
The variable valve timing camshaft actuators may stick due to dirty engine oil or a faulty control solenoid. A sticking actuator may cause a rough idle and the Check Engine Light to illuminate. Our technicians tell us the engine oil should be checked to make sure it is clean and at the proper level before replacing any parts to correct this concern.
On vehicles equipped with rear air springs, the air compressor may fail causing the rear suspension to sit low.
The fuel level sensor in the fuel tank may fail causing erratic fuel gauge operation. Our technicians tell us that on high mileage vehicles you may wish to replace the complete fuel pump module assembly if this condition occurs.
On certain 2005 - 2007 vehicles, General Motors has provided a special service policy covering the fuel level sensor, agreeing to pay 50% of the repair cost. This coverage extends for 10 years or 120,000 miles from the original "in service" date of the vehicle. Please contact your local GM dealer for more information.
To find a dealer near you, please click here»
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
Electrical power may be lost to the interior of the vehicle due to a blown 125 amp fuse located at the under hood fuse box. This fuse can blow if jumper cables are connected incorrectly. Replacing the blown fuse will commonly correct this problem.
The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.
The CD player in the radio may fail. Our technicians tell us that the radio will need to be removed and sent out to a radio repair shop to correct this condition.