Close

2003 GMC Envoy Problems

RepairPal has identified the most common problems with the 2003 GMC Envoy based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

No_car_image
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
29
Known Problems

The fuel level sensor in the fuel tank may fail causing erratic fuel gauge operation. Our technicians tell us that on high mileage vehicles you may wish to replace the complete fuel pump module assembly if this condition occurs.

On certain 2005 - 2007 vehicles, General Motors has provided a special service policy covering the fuel level sensor, agreeing to pay 50% of the repair cost. This coverage extends for 10 years or 120,000 miles from the original "in service" date of the vehicle. Please contact your local GM dealer for more information.

To find a dealer near you, please click here»

The electrical contacts in the ignition switch may fail and result in erratic instrument panel gauge operation or illumination of the Check Engine (SES) Light.

On vehicles equipped with rear air springs, the air compressor may fail causing the rear suspension to sit low.

Electrical power may be lost to the interior of the vehicle due to a blown 125 amp fuse located at the under hood fuse box. This fuse can blow if jumper cables are connected incorrectly. Replacing the blown fuse will commonly correct this problem.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

The CD player in the radio may fail. Our technicians tell us that the radio will need to be removed and sent out to a radio repair shop to correct this condition.

The engine may develop a misfire due to worn valve seats. This fault will cause the Check Engine Light to illuminate. Replacement of the cylinder head may be required to correct this concern.

The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.

The cooling fan clutch may fail causing excessive fan noise and/or the Check Engine Light to illuminate.

The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.