The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 1999 GMC Envoy problems
The fuel level sensor in the fuel tank may fail causing erratic fuel gauge operation. Our technicians tell us that on high mileage vehicles you may wish to replace the complete fuel pump module assembly if this condition occurs.
On certain 2005 - 2007 vehicles, General Motors has provided a special service policy covering the fuel level sensor, agreeing to pay 50% of the repair cost. This coverage extends for 10 years or 120,000 miles from the original "in service" date of the vehicle. Please contact your local GM dealer for more information.
To find a dealer near you, please click here»
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.
A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.
The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.
On vehicles with intermittent windshield wipers, the wiper motor circuit board may fail and cause the wipers to stop working at times. Replacing the circuit board should resolve the issue. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.