1998 GMC Envoy Problems
RepairPal has identified the most common problems with the 1998 GMC Envoy as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
On vehicles equipped with rear air springs, the air compressor may fail causing the rear suspension to sit low.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
On vehicles with intermittent windshield wipers, the wiper motor circuit board may fail and cause the wipers to stop working at times. Replacing the circuit board should resolve the issue. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.
The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.
The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.
Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.
The transmission output shaft seal may leak transmission fluid. On 2WD models, this leak can cause the transmission mount to become oil soaked, which will require replacement of the mount along with the leak repair. On 4WD models, if this seal leaks, the fluid will leak into the transfer case, causing it to become overfull.